|
GW INSTEK USG-Series
|
|
Features
- Frequency Range: 34.5MHz ~ 4400MHz- Output Power Range: -30dBm ~ 0dBm- Continuous Wave Signal Without any Modulation- Support Fixed Frequency, Frequency Sweep, Frequency Hopping & Power Sweep Mode- -107dBc/Hz Phase Noise @100kHz Offset- Frequency Resolution: 10kHz- PC USB Interface Powered and Controlled- External PC Software Support Different Operating System |
Signal Sources
|
|
|
GW INSTEK TL-06
|
|
Features
* SMD Type Measuring Clip* For : LCR-814 |
Special Applications
|
|
|
GW INSTEK SPS Series
|
|
Features:
Dual Measurement Display0.01 % High RegulationConstant Voltage and Constant Current OperationHigh EfficiencyHigh Power DensityOver Voltage ProtectionRemote Output ON/OFF Control |
Switching DC Power Supplies
|
|
|
GW INSTEK SPD-3606
|
|
Features:
Three independent, isolated output CH3 adjustable output : 0.1~5V/3A High efficiency power conversion (up to 25% more than traditional power supply) Remote output on/off control OVP to protect the DUT
OTP to protect SPD-3606 to decreas the repair rate Compact size, light weight Low Fan acoustic noise with fan speed control circuit Voltage/current protection knob (option) |
Switching DC Power Supplies
|
|
|
GW INSTEK SFG-830/830G
|
|
Features:
*30MHz Direct Digital Synthesizer(DDS)technique *20mHz Frequency Resolution *±10ppm Frequency Accuracy *12 Bit, 5M Sample/S Arbitrary Waveforms *Internally Synthesized FM, AM and Phase Modulation (PSK) *Linear and Log Sweeps *Arbitrary Modulation *Standard Interface: RS-232C*GPIB Interface (SFG-830G) |
Discontinued Products
|
|
|
GW INSTEK SFG-2100/2000 Series
|
|
Features
*DDS Technique and FPGA Chip Design *Frequency Range : 0.1Hz~4/10MHz *High Frequency Accuracy : ± 20ppm *Frequency Resolution : 100mHz *Low Distortion Sine Wave : -55dBc,0.1Hz~200kHz *Front Panel Setting Save/Recall with 10 Groups of Setting Memories *Built-In 9 Digits,150MHz/High Resolution Counter(SFG-2110 Only)*INT/EXT AM/FM Modulation (SFG-2110 Only)*LIN/LOG Sweep Mode(SFG-2110 Only) |
DDS Function Generators
|
|
|
GW INSTEK SFG-1000 Series
|
|
Features
*DDS Technique and FPGA Chip Design *Frequency Range:0.1Hz~3MHz *High Frequency Accuracy : ± 20ppm *High Frequency Stability : ± 20ppm *Max. Frequency Resolution : 100mHz *Low Distortion Sine Wave : -55dBc,0.1Hz~200kHz *Voltage Display (Only SFG-1013) |
DDS Function Generators
|
|
|
GW INSTEK RLB-001
|
|
Features:
* 1GHz Return Loss Bridge* N-Type Connector, Source/Load:Female, Couple:Male* Impedance : 50 ohms* 88 x 54 x 32(mm), 230g* For : GSP-Series |
Special Applications
|
|
|
GW INSTEK PT-100
|
|
Features:
* Temperature Test* For : GOM-802 |
Test Leads / Cables / Probes
|
|
|
GW INSTEK PSW Series
|
|
Features:
Features * Voltage Rating: 30V/80V/160V/250V/800V, Output Power Rating: 360W ~ 1080W* Constant Power Output for Multiple Range (V&I) Operation* CV/CC Priority; Particularly Suitable for the Battery and LED Industry* Adjustable Slew Rate* Series Operation: Up to 2 units (30V, 80V, 160V models only)* Parallel Operation: Up to 3 units* High Efficiency and High Power Density* 1/2, 1/3, 1/6 Rack Mount Size Design (EIA/JIS Standard) for 360W/720W/1080W* Standard Interface:... |
Programmable Switching DC Power Supplies
|
|
|
GW INSTEK PSU-Series
|
|
Features:
-Voltage Rating:6V/12.5V/20V/40V/60V-Output Power Rating: 1200W~1520W-C.V / C.C Priority ; Particularly Suitable for the Batterey & LED industry-Adjustable Slew Rate -Series and Parallel operation (2 Units in Series or 4 units in parallel)-High Efficiency and High Power Density-19 Inch Rack Mount Size Design-Stabdard Interface: LAN, RS-232 & RS-485, USB(Device / Host), Analog Control Interface-Optional Interface:GPIB, Analog Control Interface(Isolated Voltage Control), Analog... |
Programmable Switching DC Power Supplies
|
|
|
GW INSTEK PST Series
|
|
Features:Digitized programmable interfacehigh resolution 10mV, 1mA 192 x 128 LCD display, simultaneously Over-voltage, over-current, over temperature protection Intelligent fan control (changes by output power) 100 Sets memory Auto step running with timer Provided auto series and parallel function Labview driver Standard interface: RS-232C Optional: GPIB (IEEE-488.2) Optional European jack type terminal |
Programmable Linear D.C. Power Supply
|
|
|
GW INSTEK PSS Series
|
|
Features:
Digitized Programmable Interface High Resolution 10mV, 1mA High Stability, Low Drift Over-Voltage, Over-Current, Over Temperature Protection Intelligent Fan Control (Changes by Output Power) Built-in Buzzer Alarm Labview Driver Standard Interface: RS-232C Optional Interface: GPIB (IEEE-488.2) Optional European Jack Type Terminal |
Programmable Linear D.C. Power Supply
|
|
|
GW INSTEK PSM Series
|
|
Features:
Single Output Dual Range Max. 200WHigh resolution: 1mV/1mA0.01% load/line regulation, 350uVrms rippleAuto step runing with timer setting and 100 Sets memorySafety design: OVP,OCP & OTP;Output ON/OFF controlSelf-test and software calibrationHighly visible vacuum-fluorescent displayFront and rear output terminalStandard interface : RS-232C, GPIBOption : European Jack Type Terminal
|
Programmable Linear D.C. Power Supply
|
|
|
GW INSTEK PSH Series
|
|
Features:
Wide input voltage range and high power factor (P.F) high efficiency and high power density Constant voltage and constant current operation Over voltage over current and over temperature protection Low ripple and noise Output on/off control Self-test and software calibration Labview driver Standard interface : RS-232C Optional interface : GPIB ( IEEE-488.2 ) |
Programmable Switching DC Power Supplies
|
|
|
GW INSTEK PSB-2000 Series
|
|
Features:
-Output Volatge Rating:80V/800V -Output Power Rating:400W~800W-Constant Power Output for Multi-Range(V&I)Operation-Series and Parallel Operation(2 Units in Series or 4 Units in parallel Maximum) -Sequence function edited by PC will be controlled through power supply optional interface-Standard Interafce: RS-232C / USB / Analog Control Interface-Optional Interface: GPIB |
Programmable Switching DC Power Supplies
|
|
|
GW INSTEK PPT Series
|
|
Features:
Easy operation with UP/DOWN key High Resolution: 10mV, 1mA Over voltage protection, over current protection by hardware 50 Sets memory Self test and software calibration Meets UL CSA IEC Safety Regulation Auto Step Running With Timer Setting FRONT/REAR Output and Sense Switch Selectable Triple Output Auto Series and Parallel Operation Auto Tracking IEEE-488.2 and SCPI Compatible Command set Labview Driver Software Available High Stability, Low Drift 4 Digit Display |
Programmable Linear D.C. Power Supply
|
|
|
GW INSTEK PPS-3635
|
|
Features:
Easy Operation with UP/DOWN Key High Resolution: 10mV, 1mA Over Voltage Protection, Over Current Protection by Hardware 100 Sets of Memory Self Test and Software Calibration Meets UL CSA IEC Safety Regulation Auto Step Running With Time Setting FRONT/REAR Output and Sense Switch Selectable IEEE-488.2 and SCPI Compatible Command set Labview Driver Software High Stability, Low Drift 4 Digit Display |
Programmable Linear D.C. Power Supply
|
|
|
GW INSTEK PPH-1503
|
|
Features:
-Dual Range Output (0~15V/0~3A) or (0~9V/0~5A)-3.5 Inch TFT LCD Display-Constant Voltage and Constant Current Operation-Built-in DVM Measurement Function-High Measurement REsolution (1mV/0.1mA for 5A Range);(1mV/0.1uA for 5mA Range)-EXternal Relay Control Output On/Off-Sink Current Capability (Maximum:2A)-Digital Panel Control-Selectable Output and Input (DVM) Ports From Front or Rear Panel-Key Lock Function-5 Sets of Preset Memory Including Power Output ON/OFF States-High Speed... |
Programmable Linear D.C. Power Supply
|
|
|
GW INSTEK PPE-3323
|
|
Features:
Easy operation with UP/DOWN key High resolution: 10mV, 1mA Over voltage protection, over current protection by software 50 Sets memory Self test and software calibration Meets UL, CSA, IEC safety regulation Auto step running with timer setting Triple output Auto tracking RS-232 communication High stability,low drift 4 digit display |
Programmable Linear D.C. Power Supply
|
|